Wall holder for crutches
50 min1 part
Walking stick holder
3D printing1 partBeginner-friendlyNo supports
A small clip that holds a walking stick upright on the side of a table, a bedside table or the wall, so it no longer slides to the floor and is easy to reach. It takes sticks of about 20 to 22 mm, which snap in through a 19 mm opening, and the flat back sticks on with mounting tape, no drilling needed. For thicker sticks, change the diameter in the generator. 34 × 28 × 25 mm, best in PETG.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 33.62 × 28.07 × 25 mm
- Print time
- ≈ 17 min
- Filament
- ≈ 6.5 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 20%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print standing up as shown, without supports. PETG is best for clips: it bends without breaking. 3 walls (perimeters) and 20 % infill.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 33.6 mm long, 28.1 mm deep, 25 mm high
- Holders: 1 for 22 mm
- Opening to clip in: 19.1 mm
- Distance from wall: 5 mm
This model comes from the “Wall holder for round things” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Wall holder for crutches
Key tag “Home”
4 min2 parts
Luggage tag
7 min2 parts
Weekly pill box with 7 compartments
1 h 28 min2 parts
Something wrong with this model? Report a problem