Walking stick holder
17 min1 part
Wall holder for crutches
3D printing1 partBeginner-friendlyNo supports
A wall holder for a pair of forearm crutches, so they no longer slide down and fall over by the bed or in the hallway. Two clips hold tubes of about 22 mm, which snap in through a 19.1 mm opening; below, the crutches lean against the wall. It is 103.2 mm long, 38.1 mm deep and 30 mm high, sits 15 mm off the wall and has two holes for 4 mm screws, 91.2 mm apart. Measure your tubes first and change the diameter in the generator if needed.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 103.24 × 38.07 × 30 mm
- Print time
- ≈ 50 min
- Filament
- ≈ 22 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 20%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print standing up as shown, without supports. PETG is best for clips: it bends without breaking. 3 walls (perimeters) and 20 % infill.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 103.2 mm long, 38.1 mm deep, 30 mm high
- Holders: 2 for 22 mm
- Opening to clip in: 19.1 mm
- Distance from wall: 15 mm
- 2 holes for screws up to 4 mm, 91.2 mm apart
This model comes from the “Wall holder for round things” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Walking stick holder
Key tag “Home”
4 min2 parts
Luggage tag
7 min2 parts
Weekly pill box with 7 compartments
1 h 28 min2 parts
Something wrong with this model? Report a problem