Desk edge cable holder
9 min1 part
Twisted hexagonal pen holder
3D printing1 partBeginner-friendlyNo supports
A hexagonal pen holder that twists by 60° from bottom to top, 8 cm across the flats and 10 cm high. Inside it is 7.6 cm wide, with room for pens, pencils, markers, scissors and a ruler. The twisted edges make it a small sculpture on the desk, and it prints in one go without supports. In silk or two-colour filament it looks especially good.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 92.38 × 92.37 × 100 mm
- Print time
- ≈ 3 h 4 min
- Filament
- ≈ 73 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print the pot standing upright as shown and the saucer flat, both without supports. For a watertight saucer use 3 walls (perimeters). PETG copes better with sun and water than PLA.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Pot: 80 mm at the top, 80 mm at the bottom, 100 mm high
- Inside: 76 mm at the top, 98 mm deep
- Holds about 0.44 l of soil
- Twisted by 60°
- No drainage hole
This model comes from the “Plant pot” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Desk edge cable holder
Stick-on bag hook for the desk
31 min1 part
Cable clip for thick desk edges 40 mm
10 min1 part
Sign “Back in a minute”
12 min2 parts
Something wrong with this model? Report a problem