Business card box with lid
1 h 50 min2 parts
Desk edge cable holder
3D printing1 partBeginner-friendlyNo supports
A cable holder that slides onto a 25 mm desk edge and holds three cables of 6 mm underneath, without screws or glue. It keeps laptop, lamp and phone cables at the edge of the desk instead of on the floor, and suits rented flats and office desks where you can't drill. Measure your tabletop before printing: the clamp is made for exactly 25 mm and grips a little tighter so it stays put; for a thinner or thicker top, change the desk thickness in the generator.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 38.2 × 37.03 × 10 mm
- Print time
- ≈ 9 min
- Filament
- ≈ 3.4 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. PLA and PETG both work; PETG bends more easily.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 38.2 mm long, 37.03 mm high, 10 mm wide
- Cables: 3 × 6 mm
- Opening to clip in: 4.5 mm
- For tabletops 25 mm thick
This model comes from the “Cable clip” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Business card box with lid
Long pen box with lid
2 h 30 min2 parts
Desk drawer organizer with scoops
6 h 57 min2 parts
Laser-cut pen holder
Laser cutting5 parts
Something wrong with this model? Report a problem