Desk edge cable holder
9 min1 part
Stick-on bag hook for the desk
3D printing1 partBeginner-friendlyNo supports
A stick-on bag hook with a wide 35 mm opening and a 30 mm wide hook that won't cut into handles. Stuck to the side of your desk, a table leg or the end of a kitchen counter, it keeps a handbag, backpack or shopping bag off the floor and within reach. Clean the surface with alcohol, use strong double-sided foam tape, press it on firmly and wait a day; it is made for light to medium loads, so don't hang a full laptop bag on it before testing.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 47 × 50 × 30 mm
- Print time
- ≈ 31 min
- Filament
- ≈ 14 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 40%
- Walls
- 4
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. Use at least 4 walls (perimeters) or 50 % infill so it can carry a load.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 50 mm high, 47 mm deep, 30 mm wide
- Opening: 35 mm
This model comes from the “Hook” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Desk edge cable holder
Cable clip for thick desk edges 40 mm
10 min1 part
Sign “Back in a minute”
12 min2 parts
Business card box with lid
1 h 50 min2 parts
Something wrong with this model? Report a problem