Broom holder for the wall
23 min1 part
Torch holder for the wall
3D printing1 partBeginner-friendlyNo supports
A clip that keeps a torch on the wall by the door, in the garage, the workshop or the camper, so you find it straight away in the dark. It takes torches up to 28 mm thick, which snap in through a 24 mm opening, and is fixed with two 4 mm screws. Measure your torch: for a thicker or thinner one, change the diameter in the generator. 59 × 27 × 20 mm, best in PETG.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 58.68 × 26.83 × 20 mm
- Print time
- ≈ 16 min
- Filament
- ≈ 6.1 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 20%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print standing up as shown, without supports. PETG is best for clips: it bends without breaking. 3 walls (perimeters) and 20 % infill.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 58.7 mm long, 26.8 mm deep, 20 mm high
- Holders: 1 for 28 mm
- Opening to clip in: 24.4 mm
- Distance from wall: 0 mm
- 2 holes for screws up to 4 mm, 46.7 mm apart
This model comes from the “Wall holder for round things” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Broom holder for the wall
Spray can holder for two cans
2 h 39 min1 part
Shower head holder to stick on
21 min1 part
Headphone holder
55 min1 part
Something wrong with this model? Report a problem