Screw-on wall hook 20 mm
14 min1 part
Headphone holder
3D printing1 partBeginner-friendlyNo supports
A screw-on headphone holder with a 40 mm opening and a broad hook, 40 mm wide and 6 mm thick, that spreads the weight over the headband. On the wall next to your desk or on the side of a shelf, it keeps headphones or a headset within reach and the desk clear. Mount it high enough for the cable to hang freely below; it is made for light to medium loads, so test it before daily use.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 52 × 80 × 40 mm
- Print time
- ≈ 55 min
- Filament
- ≈ 26 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 40%
- Walls
- 4
- Supports
- none
Tip: Print lying on its side as shown, no supports needed. Use at least 4 walls (perimeters) or 50 % infill so it can carry a load.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 80 mm high, 52 mm deep, 40 mm wide
- Opening: 40 mm
- 2 holes for screws up to 4 mm, 20.5 mm apart
This model comes from the “Hook” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Screw-on wall hook 20 mm
Garden hose holder
1 h 24 min1 part
Bike helmet hook
52 min1 part
Tall Gridfinity bin 1 × 1
1 h 2 min1 part
Something wrong with this model? Report a problem