Jewellery box with 6 compartments
2 h 34 min2 parts
Toothbrush cup with waves
3D printing1 partBeginner-friendlyNo supports
A cup for the bathroom with twelve soft waves on the outside, 7.5 cm wide at the top and 10 cm high. It holds two to four toothbrushes and a tube of toothpaste, or make-up brushes, razors and combs. The wide base keeps it stable on the edge of the sink. Print it in PETG, which copes better with water than PLA, and rinse it out now and then.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 75 × 75 × 100 mm
- Print time
- ≈ 2 h 29 min
- Filament
- ≈ 60 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print the pot standing upright as shown and the saucer flat, both without supports. For a watertight saucer use 3 walls (perimeters). PETG copes better with sun and water than PLA.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Pot: 75 mm at the top, 68 mm at the bottom, 100 mm high
- Inside: 66.5 mm at the top, 98 mm deep
- Holds about 0.27 l of soil
- 12 waves
- No drainage hole
This model comes from the “Plant pot” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Jewellery box with 6 compartments
Box for 10 AA batteries
2 h 32 min2 parts
Cosmetics drawer organizer
4 h 38 min1 part
Jewellery drawer organizer, 24 compartments
3 h 16 min1 part
Something wrong with this model? Report a problem