Phone stand with cable opening
1 h 47 min1 part
Tablet stand with cable opening
3D printing1 partBeginner-friendlyNo supports
A wide stand for tablets up to 12 mm thick with a case, at a comfortable 65° for watching, video calls or reading at the desk. At 140 mm wide it holds a tablet steadily in landscape, and the 120 mm backrest also supports it in portrait. A 16 mm opening at the front leaves room for the charging cable. It is 78 mm deep, prints standing up without supports and has 5 mm walls for extra strength.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 140 × 77.79 × 120 mm
- Print time
- ≈ 5 h 1 min
- Filament
- ≈ 137 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print standing up as shown, without supports. With PLA, 15 % infill and 3 walls (perimeters) it is sturdy enough; for a heavy tablet use 4 walls.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Stand: 140 mm wide, 77.8 mm deep, 120 mm high
- For devices up to 12 mm thick
- Angle: 65°
- Front lip: 12 mm
- Cable opening: 16 mm wide, slot 20.4 mm above the table
This model comes from the “Phone and tablet stand” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Phone stand with cable opening
Phone charging stand for the bedside table
2 h 16 min1 part
Headphone holder
55 min1 part
Large hook for extension cords and ropes
1 h 45 min1 part
Something wrong with this model? Report a problem