Headphone holder
55 min1 part
Large hook for extension cords and ropes
3D printing1 partBeginner-friendlyNo supports
A large screw-on hook with a 70 mm opening, a 40 mm wide, 9 mm thick arm and two holes for 5 mm screws. Coiled extension cords, ropes, ratchet straps or a hose hang on it in the garage, workshop or basement without kinking, and the long 35 mm tip stops them from slipping off. Fix it into a solid wall with matching plugs, print it with plenty of walls and infill as in the print settings, and test it with a growing load before heavy coils go on it.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 88 × 120 × 40 mm
- Print time
- ≈ 1 h 45 min
- Filament
- ≈ 57 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 40%
- Walls
- 4
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. Use at least 4 walls (perimeters) or 50 % infill so it can carry a load.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 120 mm high, 88 mm deep, 40 mm wide
- Opening: 70 mm
- 2 holes for screws up to 5 mm, 24 mm apart
This model comes from the “Hook” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Headphone holder
Phone stand with cable opening
1 h 47 min1 part
Phone charging stand for the bedside table
2 h 16 min1 part
Tablet stand with cable opening
5 h 1 min1 part
Something wrong with this model? Report a problem