Phone charging stand for the bedside table
2 h 16 min1 part
Phone stand with cable opening
3D printing1 partBeginner-friendlyNo supports
A sturdy phone stand for the desk that holds your phone at 65° while it charges. The slot fits phones up to 12 mm thick with a case, and the 14 mm opening at the front leaves room for the USB-C or Lightning plug underneath. 70 mm wide, 80 mm high and 54 mm deep, it prints standing up without supports. Perfect for video calls, recipes or watching a video while you eat.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 70 × 54.41 × 80 mm
- Print time
- ≈ 1 h 47 min
- Filament
- ≈ 45 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print standing up as shown, without supports. With PLA, 15 % infill and 3 walls (perimeters) it is sturdy enough; for a heavy tablet use 4 walls.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Stand: 70 mm wide, 54.4 mm deep, 80 mm high
- For devices up to 12 mm thick
- Angle: 65°
- Front lip: 10 mm
- Cable opening: 14 mm wide, slot 20.4 mm above the table
This model comes from the “Phone and tablet stand” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Phone charging stand for the bedside table
Tablet stand with cable opening
5 h 1 min1 part
Headphone holder
55 min1 part
Large hook for extension cords and ropes
1 h 45 min1 part
Something wrong with this model? Report a problem