Phone stand with cable opening
1 h 47 min1 part
Phone charging stand for the bedside table
3D printing1 partBeginner-friendlyNo supports
A slim charging stand for the bedside table that holds your phone almost upright at 75°, so you can read the time and notifications from bed. Phones up to 12 mm thick with a case fit, and the plug and cable run through the 14 mm opening at the front. The 100 mm high backrest supports even large phones, and at 80 × 47 mm it needs little space next to the lamp.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 80 × 46.52 × 100 mm
- Print time
- ≈ 2 h 16 min
- Filament
- ≈ 57 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print standing up as shown, without supports. With PLA, 15 % infill and 3 walls (perimeters) it is sturdy enough; for a heavy tablet use 4 walls.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Stand: 80 mm wide, 46.5 mm deep, 100 mm high
- For devices up to 12 mm thick
- Angle: 75°
- Front lip: 8 mm
- Cable opening: 14 mm wide, slot 22.7 mm above the table
This model comes from the “Phone and tablet stand” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Phone stand with cable opening
Tablet stand with cable opening
5 h 1 min1 part
Headphone holder
55 min1 part
Large hook for extension cords and ropes
1 h 45 min1 part
Something wrong with this model? Report a problem