Bike pump holder
19 min1 part
Cup holder to stick on
3D printing1 partBeginner-friendlyNo supports
A cup holder to stick on, for cars, campervans or boats without enough holders. A 0.33 l can or a cup up to 67 mm slides in from above and stands on the base, which has a 27 mm hole for drips. It is 77.1 mm wide, 73.6 mm deep and 50 mm high, with a flat back for double-sided mounting tape. For the car, print it in PETG or ASA – PLA softens in summer heat.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 77.07 × 73.57 × 50 mm
- Print time
- ≈ 1 h 38 min
- Filament
- ≈ 42 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 20%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print standing up as shown, without supports. PETG is best for clips: it bends without breaking. 3 walls (perimeters) and 20 % infill.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 77.1 mm long, 73.6 mm deep, 50 mm high
- Holders: 1 for 67 mm
- Closed ring: slide in from above
- With base, drain hole 27 mm
- Distance from wall: 0 mm
This model comes from the “Wall holder for round things” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Bike pump holder
Wall holder for a kick scooter
59 min1 part
Bike helmet hook
52 min1 part
Car charging cable clip
8 min1 part
Something wrong with this model? Report a problem