Car charging cable clip
8 min1 part
Bike helmet hook
3D printing1 partBeginner-friendlyNo supports
A screw-on hook for your bike helmet, with a 50 mm opening, a 25 mm tip and a bend 30 mm wide and 7 mm thick. In the hallway or garage it gives the helmet a fixed place by the door, where it can air out after the ride – it is made for the helmet, not for hanging the bike. Hang the helmet by its straps or slip a vent over the tip; it suits light to medium loads, so test it before you trust it with a heavier helmet.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 64 × 90 × 30 mm
- Print time
- ≈ 52 min
- Filament
- ≈ 26 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 40%
- Walls
- 4
- Supports
- none
Tip: Print lying on its side as shown, no supports needed. Use at least 4 walls (perimeters) or 50 % infill so it can carry a load.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 90 mm high, 64 mm deep, 30 mm wide
- Opening: 50 mm
- 2 holes for screws up to 4 mm, 19 mm apart
This model comes from the “Hook” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Car charging cable clip
Screw-on wall hook 20 mm
14 min1 part
Headphone holder
55 min1 part
Garden hose holder
1 h 24 min1 part
Something wrong with this model? Report a problem