Bike helmet hook
52 min1 part
Car charging cable clip
3D printing1 partBeginner-friendlyNo supports
A stick-on clip for the phone charging cable in the car, made for a 4 mm cable with a tight grip and a base 15 mm wide. On the dashboard or centre console it keeps the cable within reach, so it doesn't slip into the footwell or rattle on bumpy roads. Clean the spot with alcohol first; a parked car gets very hot in the sun, so print the clip in PETG or, for the dashboard, ASA – PLA softens there – and use heat-resistant tape.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 11.4 × 7.9 × 15 mm
- Print time
- ≈ 8 min
- Filament
- ≈ 0.9 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Tip: Print lying on its side as shown, no supports needed. PLA and PETG both work; PETG bends more easily.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 11.4 mm long, 7.9 mm high, 15 mm wide
- Cables: 1 × 4 mm
- Opening to clip in: 2.6 mm
This model comes from the “Cable clip” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Bike helmet hook
Charging cable holder for 3 cables
5 min1 part
Power cable clip 8 mm
6 min1 part
Desk edge cable holder
9 min1 part
Something wrong with this model? Report a problem