Long pen box with lid
2 h 30 min2 parts
Business card box with lid
3D printing2 partsBeginner-friendlyNo supports
A slim box with lid in which business cards stand upright, 92 × 30 × 62 mm inside. It takes standard 85 × 55 mm cards as well as US-size cards of 3.5 × 2 in, and the lid closes completely over them, so they stay clean in a desk drawer or a bag. Fill it only about three-quarters full: then the cards lean a little and you can pull out the front one with two fingers.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 95.2 × 76.4 × 63.2 mm
- Print time
- ≈ 1 h 50 min
- Filament
- ≈ 44 g PLA
- Parts
- 2
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Tip: Print the box with the opening up and the lid with its top face down. No supports needed.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Outside: 95.2 × 33.2 × 63.2 mm
- Inside: 92 × 30 × 62 mm
- With lid: 64.8 mm high
This model comes from the “Box with lid” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Long pen box with lid
Desk drawer organizer with scoops
6 h 57 min2 parts
Desk edge cable holder
9 min1 part
Laser-cut pen holder
Laser cutting5 parts
Something wrong with this model? Report a problem