Garden hose holder
1 h 24 min1 part
S-hook for hanging baskets
3D printing1 partBeginner-friendlyNo supports
A long S-hook with a 40 mm middle section for hanging baskets and bird feeders. Its 25 mm upper opening fits bars, branches or eyes, the 20 mm lower one takes the ring or chain. On the balcony, the pergola or a tree, it hangs plants and feeders a little lower and easy to reach. Print it in PETG or ASA for outdoor use, as PLA softens in the sun; a basket full of wet soil is heavy, so test the hook with a growing load first.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 63 × 74.5 × 15 mm
- Print time
- ≈ 24 min
- Filament
- ≈ 12 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 40%
- Walls
- 4
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. Use at least 4 walls (perimeters) or 50 % infill so it can carry a load.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 74.5 mm high, 63 mm deep, 15 mm wide
- Opening: 20 mm at the bottom, 25 mm at the top
This model comes from the “Hook” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Garden hose holder
Garden tool hook
1 h 1 min1 part
Holder for 16 mm drip irrigation pipe
9 min1 part
Herb label
4 min2 parts
Something wrong with this model? Report a problem