Herb label
4 min2 parts
Garden hose holder
3D printing1 partBeginner-friendlyNo supports
A sturdy screw-on holder for your garden hose, with a 60 mm opening, a 30 mm tip and a hook 40 mm wide and 8 mm thick. On the house wall, in the shed or the garage it keeps the coiled hose off the ground; it is meant for light to medium loads, so test it with your hose first. Use two stainless 5 mm screws with suitable wall plugs, print it in PETG or ASA for outdoors and let the water run out before hanging the hose up.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 76 × 100 × 40 mm
- Print time
- ≈ 1 h 24 min
- Filament
- ≈ 45 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 40%
- Walls
- 4
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. Use at least 4 walls (perimeters) or 50 % infill so it can carry a load.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 100 mm high, 76 mm deep, 40 mm wide
- Opening: 60 mm
- 2 holes for screws up to 5 mm, 15.5 mm apart
This model comes from the “Hook” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Herb label
Screw-on wall hook 20 mm
14 min1 part
Headphone holder
55 min1 part
Bike helmet hook
52 min1 part
Something wrong with this model? Report a problem