Low tablet stand for drawing and writing
3 h 40 min1 part
Postcard and photo stand
3D printing1 partBeginner-friendlyNo supports
A small, simple stand that displays a postcard, a photo or a greeting card on the desk, a shelf or the windowsill. It holds cards up to 3 mm thick at 75°, so A6 postcards and 10 × 15 cm photos stand upright and steady. Only 80 mm wide and 30 mm deep, it takes up hardly any space – print a few in different colours and change the pictures now and then.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 80 × 30.28 × 60 mm
- Print time
- ≈ 1 h 14 min
- Filament
- ≈ 29 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print standing up as shown, without supports. With PLA, 15 % infill and 3 walls (perimeters) it is sturdy enough; for a heavy tablet use 4 walls.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Stand: 80 mm wide, 30.3 mm deep, 60 mm high
- For devices up to 3 mm thick
- Angle: 75°
- Front lip: 6 mm
- Without cable opening
This model comes from the “Phone and tablet stand” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Low tablet stand for drawing and writing
Business card stand for the desk
1 h 19 min1 part
Desk edge cable holder
9 min1 part
Stick-on bag hook for the desk
31 min1 part
Something wrong with this model? Report a problem