Drawer insert for medicines

3D printing2 partsBeginner-friendlyNo supports

A drawer insert with eight compartments for medicine packs, plasters and ointments, so the medicine drawer finally stays tidy. Each compartment is 73 × 87.7 mm and 58.8 mm deep, with a curved floor at the front so you can slide small things out with one finger. The insert fits a drawer with 300 × 180 mm inside and is 60 mm high. It comes in two parts that fit a 220 mm print bed.

The file is made in your browser. We only count how often it is downloaded.

Size: 299 × 179 × 60 mm
Print time: ≈ 10 h 49 min
Filament: ≈ 281 g PLA
Parts: 2

Print settings

Material: PLA
Layer height: 0.2 mm
Infill: 15%
Walls: 2
Supports: none

Tip: Print with the opening facing up, no supports needed. If the parts come out a little too wide, increase the clearance.

Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.

Adjust it

Organizer: 299 × 179 × 60 mm
Each compartment inside: 72.95 × 87.7 × 58.8 mm
Split into 2 parts (2 × 1) so each fits the print bed. A1 goes front left. STL comes as a ZIP with one file per part.

This model comes from the “Drawer organizer” generator. Open it there with these settings and change any size you like.

Open in the generator