Jewellery box with 6 compartments
2 h 34 min2 parts
Laser-cut remote control caddy
Laser cutting5 partsBeginner-friendly
An open box with finger joints for the remote controls on the coffee table, cut from five panels of 3 mm plywood or MDF and measuring 200 × 80 × 80 mm on the outside. Three or four remotes stand upright in it and stick out far enough to grab. If yours are wider, make the box longer in the generator; with a little oil or wax the wood looks good next to the sofa.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 200 × 80 × 80 mm
- Parts
- 5
- Material thickness
- 3 mm
Cutting settings
- Material thickness
- 3 mm
- Kerf
- 0.1 mm – Adjust it to your laser in the generator.
Worked for others:
Tip: Open the SVG or DXF in your laser software (e.g. LightBurn or xTool Creative Space). Cut lines are red and 0.1 mm thin. Cut a test corner first: if the joints are loose, raise the kerf; if they are too tight, lower it. Glue with wood glue.
Adjust it
- Outside: 200 × 80 × 80 mm
- Inside: 194 × 74 × 77 mm
- 5 parts, together 405.1 × 250.1 mm
This model comes from the “Laser box with finger joints” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Jewellery box with 6 compartments
Box for 10 AA batteries
2 h 32 min2 parts
Cosmetics drawer organizer
4 h 38 min1 part
Jewellery drawer organizer, 24 compartments
3 h 16 min1 part
Something wrong with this model? Report a problem