Garden hose holder
1 h 24 min1 part
Garden hose repair connector 13 mm
3D printing1 partBeginner-friendlyNo supports
A straight double barb for repairing a 13 mm (1/2 inch) garden hose, measured on the inside of the hose. Cut out the leaking or kinked section, push both ends fully over the barbs and secure each side with a hose clamp – the hose is ready to use again. It is made for low to medium pressure, for example on a hose reel or at a rain barrel, not for drinking water; for a 19 mm (3/4 inch) hose, change both diameters in the generator.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 15.08 × 15.08 × 52 mm
- Print time
- ≈ 26 min
- Filament
- ≈ 5.4 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print standing as shown, no supports needed. With 3–4 walls (perimeters) it becomes watertight; a hose clamp holds hoses on the barbs.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 15.08 mm diameter, 52 mm high
- Bottom: hose barb for a hose 13 mm inside, 25 mm long
- Top: hose barb for a hose 13 mm inside, 25 mm long
- Narrowest opening: 9 mm
This model comes from the “Pipe adapter” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Garden hose holder
Garden tool hook
1 h 1 min1 part
S-hook for hanging baskets
24 min1 part
Holder for 16 mm drip irrigation pipe
9 min1 part
Something wrong with this model? Report a problem