Car charging cable clip
8 min1 part
Wall clip for the EV charging cable
3D printing1 partBeginner-friendlyNo supports
A strong wall clip for the charging cable of an electric car or a thick extension cable in the garage. Cables up to 28 mm snap into the clip through a 21 mm opening and hang tidily off the floor. It is 56.2 mm long, 29.6 mm high and 25 mm wide, with two holes for screws up to 3.5 mm, 45.2 mm apart. Print several and hang the cable in loops.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 56.2 × 29.57 × 25 mm
- Print time
- ≈ 21 min
- Filament
- ≈ 8 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. PLA and PETG both work; PETG bends more easily.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 56.2 mm long, 29.57 mm high, 25 mm wide
- Cables: 1 × 28 mm
- Opening to clip in: 21 mm
- 2 holes for screws up to 3.5 mm, 45.2 mm apart
This model comes from the “Cable clip” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Car charging cable clip
Dashcam cable clip
5 min1 part
Bike helmet hook
52 min1 part
Bike pump holder
19 min1 part
Something wrong with this model? Report a problem