Car charging cable clip
8 min1 part
Dashcam cable clip
3D printing1 partBeginner-friendlyNo supports
A small stick-on clip with a firm grip for one cable up to 3.5 mm, made for the power lead of a dashcam or a sat nav. A few of them run the cable neatly along the headliner, the A-pillar trim or the edge of the dashboard, so it doesn't dangle in your field of view. Clean the spot with alcohol and use heat-resistant double-sided tape, as it gets very hot behind the windscreen; print in PETG or ASA, because PLA softens in a parked car in summer.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 10.9 × 7.46 × 10 mm
- Print time
- ≈ 5 min
- Filament
- ≈ 0.5 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. PLA and PETG both work; PETG bends more easily.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 10.9 mm long, 7.46 mm high, 10 mm wide
- Cables: 1 × 3.5 mm
- Opening to clip in: 2.28 mm
This model comes from the “Cable clip” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Car charging cable clip
Wall clip for the EV charging cable
21 min1 part
Bike helmet hook
52 min1 part
Bike pump holder
19 min1 part
Something wrong with this model? Report a problem