Vacuum cleaner adapter 35 to 32 mm
39 min1 part
Dust extraction adapter for power tools 27 to 35 mm
3D printing1 partBeginner-friendlyNo supports
An adapter that connects the dust outlet of a sander, jigsaw or planer to a workshop vacuum hose. The 27 mm socket slides over the tool's outlet, and the 35 mm spigot goes into the hose cuff. With the dust extracted right at the tool, the air stays cleaner and the sandpaper lasts longer. Measure the outside of your tool's outlet and the inside of the hose cuff before printing and enter both values in the generator; a strip of insulating tape seals small gaps.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 34.7 × 34.7 × 54.7 mm
- Print time
- ≈ 37 min
- Filament
- ≈ 13 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print standing as shown, no supports needed. With 3–4 walls (perimeters) it becomes watertight; a hose clamp holds hoses on the barbs.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 34.7 mm diameter, 54.7 mm high
- Bottom: socket for a pipe 27 mm outside, 25 mm deep
- Top: spigot for a pipe 35 mm inside, 25 mm long
- Narrowest opening: 24.3 mm
This model comes from the “Pipe adapter” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Vacuum cleaner adapter 35 to 32 mm
Dust extraction adapter 100 to 35 mm
2 h 25 min1 part
Shelf label “Screws”
3 min2 parts
Screw box with 6 compartments
3 h 28 min2 parts
Something wrong with this model? Report a problem