Drawer organizer for small parts, 6 × 4
6 h 20 min2 parts
Screw box with 6 compartments
3D printing2 partsBeginner-friendlyNo supports
A box with lid for screws, nuts and washers, 120 × 80 × 40 mm inside and split into 3 × 2 compartments. Give each thread size its own compartment, from small M3 screws to M8 bolts, and nothing gets mixed up when you carry the box to the job. The lid is flat on top, so you can print several screw boxes and stack them on the shelf.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 123.2 × 176.4 × 41.2 mm
- Print time
- ≈ 3 h 28 min
- Filament
- ≈ 90 g PLA
- Parts
- 2
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Tip: Print the box with the opening up and the lid with its top face down. No supports needed.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Outside: 123.2 × 83.2 × 41.2 mm
- Inside: 120 × 80 × 40 mm
- With lid: 42.8 mm high
- Each compartment: 38.93 × 39.2 mm, 33.4 mm deep
This model comes from the “Box with lid” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Drawer organizer for small parts, 6 × 4
Shelf label “Screws”
3 min2 parts
Vacuum cleaner adapter 35 to 32 mm
39 min1 part
Dust extraction adapter 100 to 35 mm
2 h 25 min1 part
Something wrong with this model? Report a problem