Drawer organizer for socks and underwear

3D printing6 partsBeginner-friendlyNo supports

Nine compartments of about 98 × 131 mm and 80 mm high for socks, tights and underwear, made for a wardrobe drawer of 300 × 400 mm inside. Rolled up, each pair gets its spot and you see at a glance what's there, instead of rummaging through a mixed pile in the morning. It comes in six parts sized for a 220 mm print bed that stand together in the drawer; for other drawers, enter your inside measurements in the generator.

The file is made in your browser. We only count how often it is downloaded.

Size: 299 × 399 × 80 mm
Print time: ≈ 23 h 53 min
Filament: ≈ 615 g PLA
Parts: 6

Print settings

Material: PLA
Layer height: 0.2 mm
Infill: 15%
Walls: 2
Supports: none

Tip: Print with the opening facing up, no supports needed. If the parts come out a little too wide, increase the clearance.

Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.

Adjust it

Organizer: 299 × 399 × 80 mm
Each compartment inside: 97.67 × 130.6 × 78.8 mm
Split into 6 parts (2 × 3) so each fits the print bed. A1 goes front left. STL comes as a ZIP with one file per part.

This model comes from the “Drawer organizer” generator. Open it there with these settings and change any size you like.

Open in the generator