Charging cable holder for 3 cables
5 min1 part
Double cable clip for skirting boards
3D printing1 partBeginner-friendlyNo supports
A stick-on clip for two cables up to 6 mm side by side, for example a network cable and a power lead, made to run along a skirting board or door frame. Placed every 30 to 40 cm, it keeps the cables flat against the wall, so nobody trips over them and the vacuum cleaner doesn't catch them. Stick the clips onto the clean, dry top edge of the skirting board with double-sided tape and press the cables in; for other cables, change the diameter and number in the generator.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 24.3 × 9.33 × 10 mm
- Print time
- ≈ 5 min
- Filament
- ≈ 1.3 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. PLA and PETG both work; PETG bends more easily.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 24.3 mm long, 9.33 mm high, 10 mm wide
- Cables: 2 × 6 mm
- Opening to clip in: 4.5 mm
This model comes from the “Cable clip” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Charging cable holder for 3 cables
Power cable clip 8 mm
6 min1 part
Clip for thick cables 14 mm
12 min1 part
Cable clip for 6 cables
10 min1 part
Something wrong with this model? Report a problem