Power cable clip 8 mm
6 min1 part
Charging cable holder for 3 cables
3D printing1 partBeginner-friendlyNo supports
A stick-on holder for three charging cables of 4 mm, which snap into their clips and stay put. On the edge of the desk or the bedside table it keeps phone, tablet and headphone cables within reach instead of letting them slip down the back. Clip each cable in a hand's width behind the plug: the plug is wider than the clip, so the end can't slide through and is always ready to grab.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 29.2 × 7.67 × 10 mm
- Print time
- ≈ 5 min
- Filament
- ≈ 1.5 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. PLA and PETG both work; PETG bends more easily.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 29.2 mm long, 7.67 mm high, 10 mm wide
- Cables: 3 × 4 mm
- Opening to clip in: 3 mm
This model comes from the “Cable clip” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Power cable clip 8 mm
Clip for thick cables 14 mm
12 min1 part
Cable clip for 6 cables
10 min1 part
Drawer organizer for cables and chargers
9 h 44 min2 parts
Something wrong with this model? Report a problem