Charging cable holder for 3 cables
5 min1 part
Cable clip for 6 cables
3D printing1 partBeginner-friendlyNo supports
A screw-on cable clip that holds six cables of 5 mm side by side, each in its own snap-in holder. Behind the TV, under the desk or along the wall it keeps USB, audio and charging cables in order instead of in a tangle. Since every cable has its own place, you can unclip one or add a new one without disturbing the others; screw the clip on first, then press the cables in one by one.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 79.9 × 8.5 × 10 mm
- Print time
- ≈ 10 min
- Filament
- ≈ 3.7 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Tip: Print lying on its side as shown, no supports needed. PLA and PETG both work; PETG bends more easily.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 79.9 mm long, 8.5 mm high, 10 mm wide
- Cables: 6 × 5 mm
- Opening to clip in: 3.75 mm
- 2 holes for screws up to 3.5 mm, 68.9 mm apart
This model comes from the “Cable clip” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Charging cable holder for 3 cables
Power cable clip 8 mm
6 min1 part
Clip for thick cables 14 mm
12 min1 part
Drawer organizer for cables and chargers
9 h 44 min2 parts
Something wrong with this model? Report a problem