Charging cable holder for 3 cables
5 min1 part
Power cable clip 8 mm
3D printing1 partBeginner-friendlyNo supports
A screw-on clip for a single power cable of 8 mm, with a tab and a countersunk hole at each end. It runs the cable of a lamp, a TV or a desk along the wall, the skirting board or the underside of a table, where it no longer dangles. Place one clip just before and one just after each corner: the cable then follows the edges neatly and snaps out again when you rearrange the room.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 33.4 × 10.99 × 12 mm
- Print time
- ≈ 6 min
- Filament
- ≈ 1.6 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. PLA and PETG both work; PETG bends more easily.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 33.4 mm long, 10.99 mm high, 12 mm wide
- Cables: 1 × 8 mm
- Opening to clip in: 6 mm
- 2 holes for screws up to 3.5 mm, 22.4 mm apart
This model comes from the “Cable clip” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Charging cable holder for 3 cables
Clip for thick cables 14 mm
12 min1 part
Cable clip for 6 cables
10 min1 part
Drawer organizer for cables and chargers
9 h 44 min2 parts
Something wrong with this model? Report a problem