Charging cable holder for 3 cables
5 min1 part
Clip for thick cables 14 mm
3D printing1 partBeginner-friendlyNo supports
A screw-on clip for two thick cables of 14 mm, with sturdier 2.2 mm clip walls and a width of 14 mm. In the workshop, garage or garden it runs heavy extension cables, a welding cable or a compressor hose neatly along the wall. The thicker walls hold stiff, heavy cables that would push a thin clip open; measure your cables first, because for thinner ones a 14 mm clip is too loose.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 60.7 × 16.39 × 14 mm
- Print time
- ≈ 12 min
- Filament
- ≈ 4.3 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. PLA and PETG both work; PETG bends more easily.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 60.7 mm long, 16.39 mm high, 14 mm wide
- Cables: 2 × 14 mm
- Opening to clip in: 10.5 mm
- 2 holes for screws up to 3.5 mm, 49.7 mm apart
This model comes from the “Cable clip” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Charging cable holder for 3 cables
Power cable clip 8 mm
6 min1 part
Cable clip for 6 cables
10 min1 part
Drawer organizer for cables and chargers
9 h 44 min2 parts
Something wrong with this model? Report a problem