Desk edge cable holder
9 min1 part
Clip for notes and receipts
3D printing1 partBeginner-friendlyNo supports
A clip with flat jaws for a few notes, receipts or recipe cards – the hole in its spring hangs it on a nail or a pin board. Paper up to 60 mm wide fits fully between the jaws; wider sheets are simply clamped at the edge. It is 76.5 mm long and 15 mm wide and prints flat in one piece, without supports.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 76.5 × 19.56 × 15 mm
- Print time
- ≈ 18 min
- Filament
- ≈ 6.9 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print flat as shown, without supports – the clip comes off the printer open. Close it once after printing: press the arms together until the upper arm clicks in under the nose of the hook. To open, push the tab of the hook outwards. PETG springs best and copes with the freezer; PLA works too.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size as printed: 76.5 × 19.6 mm, 15 mm high
- Clamping length 60 mm, 15 mm wide
- Flat arms, no ridge
- Hole in the spring: 6 mm, to hang it up
This model comes from the “Bag clip” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Desk edge cable holder
Stick-on bag hook for the desk
31 min1 part
Cable clip for thick desk edges 40 mm
10 min1 part
Sign “Back in a minute”
12 min2 parts
Something wrong with this model? Report a problem