Bike helmet hook
52 min1 part
Headrest hook for the car
3D printing1 partBeginner-friendlyNo supports
An S-hook for the car headrest: the small bow (16 mm) goes round a headrest post, the large one (30 mm) holds a handbag, a shopping bag or a rubbish bag behind the seat. That keeps bags from sliding around in the footwell. It is 65 mm high, 64 mm deep, 15 mm wide and 6 mm thick; print two, one for each post. In a hot car PLA goes soft, so print it in PETG.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 64 × 65 × 15 mm
- Print time
- ≈ 21 min
- Filament
- ≈ 10 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 40%
- Walls
- 4
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. Use at least 4 walls (perimeters) or 50 % infill so it can carry a load.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 65 mm high, 64 mm deep, 15 mm wide
- Opening: 30 mm at the bottom, 16 mm at the top
This model comes from the “Hook” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Bike helmet hook
Car charging cable clip
8 min1 part
Dashcam cable clip
5 min1 part
Bike pump holder
19 min1 part
Something wrong with this model? Report a problem