Screw-on wall hook 20 mm
14 min1 part
Stick-on towel hook
3D printing1 partBeginner-friendlyNo supports
A stick-on towel hook with a 25 mm opening and a smooth back 20 mm wide for double-sided tape, so you don't need to drill. It holds a hand towel, a tea towel or an oven glove on tiles, glass or a cupboard door, which is handy in a rented flat. Clean the surface with alcohol, use waterproof tape in the bathroom, press it on firmly and wait a day; then test it, as it is made for light to medium loads.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 35 × 60 × 20 mm
- Print time
- ≈ 19 min
- Filament
- ≈ 8.4 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 40%
- Walls
- 4
- Supports
- none
Tip: Print lying on its side as shown, no supports needed. Use at least 4 walls (perimeters) or 50 % infill so it can carry a load.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 60 mm high, 35 mm deep, 20 mm wide
- Opening: 25 mm
This model comes from the “Hook” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Screw-on wall hook 20 mm
S-hook 30 mm
22 min1 part
Stick-on key hook
8 min1 part
Coat hook
30 min1 part
Something wrong with this model? Report a problem