Screw-on wall hook 20 mm
14 min1 part
Stick-on key hook
3D printing1 partBeginner-friendlyNo supports
A small stick-on key hook with a 12 mm opening and a 10 mm tip that keeps the key ring from slipping off. Stuck by the front door, inside a cupboard door or on a board, it gives every bunch of keys a fixed place. Put three or four in a row for the whole household; it is made for light to medium loads, so press it on firmly with double-sided tape, wait a day and test it before daily use.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 22 × 40 × 12 mm
- Print time
- ≈ 8 min
- Filament
- ≈ 3.3 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 40%
- Walls
- 4
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. Use at least 4 walls (perimeters) or 50 % infill so it can carry a load.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 40 mm high, 22 mm deep, 12 mm wide
- Opening: 12 mm
This model comes from the “Hook” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Screw-on wall hook 20 mm
Stick-on towel hook
19 min1 part
S-hook 30 mm
22 min1 part
Coat hook
30 min1 part
Something wrong with this model? Report a problem