Screw-on wall hook 20 mm
14 min1 part
S-hook 30 mm
3D printing1 partBeginner-friendlyNo supports
An S-hook with two 30 mm openings for hanging things from a rod or rail. In the wardrobe it carries bags and belts, in the kitchen ladles or mugs, and in the shed tools that would otherwise lie around – light to medium loads, which you should test first. The top opening takes rods up to 30 mm, as in many wardrobes; for a thin kitchen rail, make it smaller in the generator so the hook doesn't wobble.
Download
Calculated in your browser. Nothing is uploaded.
Join in
- Size
- 75 × 60 × 15 mm
- Print time
- ≈ 22 min
- Filament
- ≈ 9.9 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 40%
- Walls
- 4
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. Use at least 4 walls (perimeters) or 50 % infill so it can carry a load.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 60 mm high, 75 mm deep, 15 mm wide
- Opening: 30 mm at the bottom, 30 mm at the top
This model comes from the “Hook” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Screw-on wall hook 20 mm
Stick-on towel hook
19 min1 part
Stick-on key hook
8 min1 part
Coat hook
30 min1 part
Something wrong with this model? Report a problem