Screw-on wall hook 20 mm
14 min1 part
Coat hook
3D printing1 partBeginner-friendlyNo supports
A screw-on coat hook with a 30 mm opening and a long 25 mm tip, so jackets and bags stay on. A few of them in a row on the wall or on a wooden board make a simple coat rack for the hallway, the kids' room or the workshop. Space them a hand's width apart so thick jackets don't crowd each other; they are meant for light to medium loads, so test them with a heavy winter coat before everyday use.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 44 × 80 × 20 mm
- Print time
- ≈ 30 min
- Filament
- ≈ 15 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 40%
- Walls
- 4
- Supports
- none
Tip: Print lying on its side as shown, no supports needed. Use at least 4 walls (perimeters) or 50 % infill so it can carry a load.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 80 mm high, 44 mm deep, 20 mm wide
- Opening: 30 mm
- 2 holes for screws up to 4 mm, 19 mm apart
This model comes from the “Hook” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Screw-on wall hook 20 mm
Stick-on towel hook
19 min1 part
S-hook 30 mm
22 min1 part
Stick-on key hook
8 min1 part
Something wrong with this model? Report a problem