Stick-on towel hook
19 min1 part
Screw-on wall hook 20 mm
3D printing1 partBeginner-friendlyNo supports
A simple screw-on wall hook with a 20 mm opening and two holes for 4 mm countersunk screws. It suits the hallway, kitchen or workshop and carries light to medium loads such as keys, a dog lead, a bag or a tea towel. Use wall plugs that match your wall, drive the screws in until the heads sit flush, and test the hook with a gradually growing load before anything valuable hangs on it.
Download
Calculated in your browser. Nothing is uploaded.
- Size
- 30 × 60 × 15 mm
- Print time
- ≈ 14 min
- Filament
- ≈ 6.1 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 40%
- Walls
- 4
- Supports
- none
Tip: Print lying on its side as shown, no supports needed. Use at least 4 walls (perimeters) or 50 % infill so it can carry a load.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 60 mm high, 30 mm deep, 15 mm wide
- Opening: 20 mm
- 2 holes for screws up to 4 mm, 17 mm apart
This model comes from the “Hook” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Something wrong with this model? Report a problem