Flower pot 10 cm with saucer
3 h 36 min2 parts
Seedling pot 5 cm
3D printing1 partBeginner-friendlyNo supports
A small, light pot for sowing seeds and growing seedlings, 5 cm wide and 5 cm high, with thin 1.2 mm walls and a 6 mm drainage hole. Fill it with seed compost, sow tomatoes, peppers or flowers and set the pots in a tray on the windowsill. They are reusable year after year, and each one takes only about half an hour and around 12 g of filament.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 50 × 50 × 50 mm
- Print time
- ≈ 35 min
- Filament
- ≈ 12 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print the pot standing upright as shown and the saucer flat, both without supports. For a watertight saucer use 3 walls (perimeters). PETG copes better with sun and water than PLA.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Pot: 50 mm at the top, 40 mm at the bottom, 50 mm high
- Inside: 47.6 mm at the top, 48.8 mm deep
- Holds about 53 ml of soil
- Drainage hole: 6 mm
This model comes from the “Plant pot” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Flower pot 10 cm with saucer
Grooved flower pot with saucer
4 h 38 min2 parts
Twisted hexagonal flower pot
3 h 22 min2 parts
Mini pot for succulents
1 h 19 min2 parts
Something wrong with this model? Report a problem