Grooved flower pot with saucer
4 h 38 min2 parts
Flower pot 10 cm with saucer
3D printing2 partsBeginner-friendlyNo supports
A classic flower pot, 10 cm wide at the top and 9 cm high, with a matching saucer. It holds about 0.45 l of soil – enough for a basil plant, a small herb or a houseplant from the garden centre. Water runs out through the 10 mm hole in the bottom, and six ribs in the saucer keep the pot above the water so the roots don't rot.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 203.2 × 100 × 90 mm
- Print time
- ≈ 3 h 36 min
- Filament
- ≈ 88 g PLA
- Parts
- 2
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print the pot standing upright as shown and the saucer flat, both without supports. For a watertight saucer use 3 walls (perimeters). PETG copes better with sun and water than PLA.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Pot: 100 mm at the top, 80 mm at the bottom, 90 mm high
- Inside: 96 mm at the top, 88 mm deep
- Holds about 0.45 l of soil
- Drainage hole: 10 mm
- Saucer: 93.2 mm wide, 14 mm high
This model comes from the “Plant pot” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Grooved flower pot with saucer
Twisted hexagonal flower pot
3 h 22 min2 parts
Mini pot for succulents
1 h 19 min2 parts
Hexagonal cactus pot with grooves
2 h 5 min2 parts
Something wrong with this model? Report a problem