Flower pot 10 cm with saucer
3 h 36 min2 parts
Twisted hexagonal flower pot
3D printing2 partsBeginner-friendlyNo supports
A hexagonal flower pot that turns by 45° from bottom to top, 9 cm across the flats at the top and 8.5 cm high, with a hexagonal saucer. The twist makes the edges run around the pot like a spiral – an eye-catcher for succulents, small herbs or a cutting. It holds about 0.37 l of soil, prints without supports and has a 10 mm drainage hole.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 208.76 × 100.39 × 85 mm
- Print time
- ≈ 3 h 22 min
- Filament
- ≈ 83 g PLA
- Parts
- 2
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print the pot standing upright as shown and the saucer flat, both without supports. For a watertight saucer use 3 walls (perimeters). PETG copes better with sun and water than PLA.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Pot: 90 mm at the top, 72 mm at the bottom, 85 mm high
- Inside: 86 mm at the top, 83 mm deep
- Holds about 0.37 l of soil
- Twisted by 45°
- Drainage hole: 10 mm
- Saucer: 85.2 mm wide, 14 mm high
This model comes from the “Plant pot” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Flower pot 10 cm with saucer
Grooved flower pot with saucer
4 h 38 min2 parts
Mini pot for succulents
1 h 19 min2 parts
Hexagonal cactus pot with grooves
2 h 5 min2 parts
Something wrong with this model? Report a problem