Drawer organizer for small parts, 6 × 4

3D printing2 partsBeginner-friendlyNo supports

A drawer organizer with 24 square compartments in a 6 × 4 grid, made for a drawer of 240 × 160 mm inside. Each compartment is about 38 mm across, a good size for screws, nuts, washers, electronic components or beads that would get lost in a big box. It comes in two parts that stand side by side; if you often pick out tiny parts, switch on the scoop in the generator so they slide out over a curved front.

Calculated in your browser. Nothing is uploaded.

Size: 239 × 159 × 30 mm
Print time: ≈ 6 h 20 min
Filament: ≈ 165 g PLA
Parts: 2

Print settings

Material: PLA
Layer height: 0.2 mm
Infill: 15%
Walls: 2
Supports: none

Tip: Print with the opening facing up, no supports needed. If the parts come out a little too wide, increase the clearance.

Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.

Adjust it

Organizer: 239 × 159 × 30 mm
Each compartment inside: 38.23 × 38.25 × 28.8 mm
Split into 2 parts (2 × 1) so each fits the print bed. A1 goes front left. STL comes as a ZIP with one file per part.

This model comes from the “Drawer organizer” generator. Open it there with these settings and change any size you like.

Open in the generator