Pantry label “Flour”
6 min2 parts
S-hook for kitchen rails 16 mm
3D printing1 partBeginner-friendlyNo supports
A slim S-hook whose upper opening fits kitchen rails up to 16 mm, with a 25 mm lower hook for utensils. Several of them turn a rail into a tidy place for ladles, whisks, oven gloves, mugs or a small herb pot, freeing up drawers and worktop. Measure your rail before printing: if it is thinner or thicker, change the upper opening in the generator so the hook sits snugly and doesn't slide around; it carries light loads.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 53 × 43.5 × 10 mm
- Print time
- ≈ 11 min
- Filament
- ≈ 4.4 g PLA
- Parts
- 1
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 40%
- Walls
- 4
- Supports
- none
Worked for others:
Tip: Print lying on its side as shown, no supports needed. Use at least 4 walls (perimeters) or 50 % infill so it can carry a load.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size: 43.5 mm high, 53 mm deep, 10 mm wide
- Opening: 25 mm at the bottom, 16 mm at the top
This model comes from the “Hook” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Pantry label “Flour”
Tea bag box with 2 compartments
5 h 34 min2 parts
Cutlery tray 300 × 480 mm
20 h 23 min4 parts
Drawer organizer for spices
9 h 48 min2 parts
Something wrong with this model? Report a problem