Cutlery tray 300 × 480 mm

3D printing4 partsBeginner-friendlyNo supports

A cutlery tray for a drawer of 300 × 480 mm inside: ten compartments in two rows, each almost 24 cm long, so most table knives fit too. Use the front row for everyday knives, forks and spoons and the back row for serving spoons, cake forks and kitchen helpers. It comes as four parts sized for a 256 mm print bed, which stand side by side in the drawer; on a smaller bed the generator makes the compartments shorter.

Calculated in your browser. Nothing is uploaded.

Size: 299 × 479 × 50 mm
Print time: ≈ 20 h 23 min
Filament: ≈ 541 g PLA
Parts: 4

Print settings

Material: PLA
Layer height: 0.2 mm
Infill: 15%
Walls: 2
Supports: none

Tip: Print with the opening facing up, no supports needed. If the parts come out a little too wide, increase the clearance.

Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.

Adjust it

Organizer: 299 × 479 × 50 mm
Each compartment inside: 58.12 × 237.1 × 48.8 mm
Split into 4 parts (2 × 2) so each fits the print bed. A1 goes front left. STL comes as a ZIP with one file per part.

This model comes from the “Drawer organizer” generator. Open it there with these settings and change any size you like.

Open in the generator