Drawer organizer for spices

3D printing2 partsBeginner-friendlyNo supports

Ten compartments of about 58 × 98 mm for spice packets and small spice jars, made for a kitchen drawer of 300 × 200 mm inside. Packets stand upright with the label facing up, sorted from pepper and paprika to baking spices, and open bags no longer spill in the drawer. It comes in two parts sized for a 220 mm print bed that stand side by side; for other drawers, enter your inside measurements in the generator.

The file is made in your browser. We only count how often it is downloaded.

Size: 299 × 199 × 50 mm
Print time: ≈ 9 h 48 min
Filament: ≈ 255 g PLA
Parts: 2

Print settings

Material: PLA
Layer height: 0.2 mm
Infill: 15%
Walls: 2
Supports: none

Tip: Print with the opening facing up, no supports needed. If the parts come out a little too wide, increase the clearance.

Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.

Adjust it

Organizer: 299 × 199 × 50 mm
Each compartment inside: 58.12 × 97.7 × 48.8 mm
Split into 2 parts (2 × 1) so each fits the print bed. A1 goes front left. STL comes as a ZIP with one file per part.

This model comes from the “Drawer organizer” generator. Open it there with these settings and change any size you like.

Open in the generator