Round bases 25 mm for miniatures, 10 pieces
25 min10 parts
Round bases 50 mm for miniatures, 4 pieces
3D printing4 partsBeginner-friendlyNo supports
Four round bases, 50 mm across and 4 mm high with a bevelled edge, for large miniatures such as ogres, monsters or small vehicles. The wide base keeps heavy figures steady on the table and leaves room for rocks, roots or ruins. Fix the figure with superglue or pins; for other sizes, simply change the diameter in the generator.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 50 × 50 × 4 mm
- Print time
- ≈ 41 min
- Filament
- ≈ 22 g PLA
- Parts
- 4
Print settings
- Material
- PLA
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 2
- Supports
- none
Worked for others:
Tip: Print standing upright as shown, no supports needed. For washers under 1 mm use a layer height of 0.1–0.2 mm. The STL holds all pieces; in the 3MF each piece is its own object.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Outside 50 mm, no hole, 4 mm high
- Pieces: 4
This model comes from the “Spacer” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Round bases 25 mm for miniatures, 10 pieces
Round bases 32 mm for miniatures, 6 pieces
27 min6 parts
Round bases 40 mm for miniatures, 4 pieces
27 min4 parts
Hexagonal bases 25 mm, 10 pieces
28 min10 parts
Something wrong with this model? Report a problem