Drawer organizer for cables and chargers

3D printing2 partsBeginner-friendlyNo supports

Six large compartments for cables and chargers, each almost 10 cm square and 60 mm high: this drawer organizer fills a drawer of 300 × 200 mm inside. Coiled charging cables, phone chargers, adapters, earphones and a power bank each get their own compartment instead of tangling in one heap. It comes in two parts; give each device one compartment for its charger and cable, rolled loosely and held with a hook-and-loop tie.

Calculated in your browser. Nothing is uploaded.

Size: 299 × 199 × 60 mm
Print time: ≈ 9 h 44 min
Filament: ≈ 253 g PLA
Parts: 2

Print settings

Material: PLA
Layer height: 0.2 mm
Infill: 15%
Walls: 2
Supports: none

Tip: Print with the opening facing up, no supports needed. If the parts come out a little too wide, increase the clearance.

Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.

Adjust it

Organizer: 299 × 199 × 60 mm
Each compartment inside: 97.67 × 97.7 × 58.8 mm
Split into 2 parts (2 × 1) so each fits the print bed. A1 goes front left. STL comes as a ZIP with one file per part.

This model comes from the “Drawer organizer” generator. Open it there with these settings and change any size you like.

Open in the generator