Bag clip with sealing ridge
19 min1 part
Freezer bag clip
3D printing1 partBeginner-friendlyNo supports
A strong clip for frozen vegetables, chips and berries from the freezer: the opened bag stays closed and nothing spills into the drawer. It takes bags up to 150 mm wide, and its arms are 3.5 mm thick, so it clamps firmly. The clip is 14 mm wide and prints flat in one piece. Print it in PETG – it stays springy in the cold, where PLA becomes brittle.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 169.05 × 33.62 × 14 mm
- Print time
- ≈ 34 min
- Filament
- ≈ 14 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print flat as shown, without supports – the clip comes off the printer open. Close it once after printing: press the arms together until the upper arm clicks in under the nose of the hook. To open, push the tab of the hook outwards. PETG springs best and copes with the freezer; PLA works too.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size as printed: 169 × 33.6 mm, 14 mm high
- Clamping length 150 mm, 14 mm wide
- With sealing ridge and groove
- Hole in the spring: 7 mm, to hang it up
This model comes from the “Bag clip” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Bag clip with sealing ridge
Set of four bag clips
1 h1 part
Bag clip for coffee bags
31 min1 part
Clip for paper bags
23 min1 part
Something wrong with this model? Report a problem