Set of four bag clips
1 h1 part
Bag clip with sealing ridge
3D printing1 partBeginner-friendlyNo supports
A bag clip for crisps, nuts or cereal that really keeps the bag shut. A ridge on one arm presses the folded bag into a groove in the other, and a snap hook holds the clip closed. The bag may be up to 90 mm wide when folded; the clip is 106.5 mm long and 12 mm wide. It prints flat and open in one piece, without supports – close it once, and it springs open again when you press the tab of the hook.
Download
The file is made in your browser. We only count how often it is downloaded.
Join in
- Size
- 106.5 × 26.95 × 12 mm
- Print time
- ≈ 19 min
- Filament
- ≈ 7.6 g PETG
- Parts
- 1
Print settings
- Material
- PETG
- Layer height
- 0.2 mm
- Infill
- 15%
- Walls
- 3
- Supports
- none
Worked for others:
Tip: Print flat as shown, without supports – the clip comes off the printer open. Close it once after printing: press the arms together until the upper arm clicks in under the nose of the hook. To open, push the tab of the hook outwards. PETG springs best and copes with the freezer; PLA works too.
Estimated by our slicer-like calculation for a 0.4 mm nozzle. Your slicer may show slightly different values.
Adjust it
- Size as printed: 106.5 × 27 mm, 12 mm high
- Clamping length 90 mm, 12 mm wide
- With sealing ridge and groove
- Hole in the spring: 6 mm, to hang it up
This model comes from the “Bag clip” generator. Open it there with these settings and change any size you like.
Open in the generatorSimilar models
Set of four bag clips
Bag clip for coffee bags
31 min1 part
Freezer bag clip
34 min1 part
Clip for paper bags
23 min1 part
Something wrong with this model? Report a problem